StarQuest USA

Open to all Starion and Conquest enthusiasts.
 
HomeRegisterLog in

Share | 
 

 CAD Final

View previous topic View next topic Go down 
AuthorMessage
Dz Nutz
Administration
Administration
avatar

Posts : 294
Join date : 2010-11-24
Age : 42
Location : Sycamore, OK

PostSubject: CAD Final   2011-01-28, 8:47 am

So in my Solidworks class I did a complete G54B block with rotating assembly ( crank & pistons). I have to do better than that in this class, so I am taking ideas of what to "build" for my final project in this class.

I was going to do a custom MPI intake for the ole G54B but I am afraid it may be too easy & not include enough parts. I may see bout including a TB & injectors & all the goodies with it.

Now I wish I had not stripped the old intake for scrap aluminum so I could get dimensions on it.

Also on my mind is a rear diffuser / bumper assembly?


If you have any ideas let me know & I may go another route.
Back to top Go down
http://starquestusa.forumotion.com
 
CAD Final
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» K100 final drive for a K75 ??
» leinster minor club final
» Junior A Football Final 2010 Robertstown V Caragh
» All Ireland colleges senior league final DIT v UCC
» Final Drive Chain Sprocket for my Fulmar

Permissions in this forum:You cannot reply to topics in this forum
StarQuest USA :: Community :: ALMOST Anything Goes-
Jump to: